Dataplex DPX-213 Spezifikationen PDF herunterladen (Seite 5)

RailCorp Engineering Manual — Signals — Equipment Manual

Cerberus Level Crossing Monitor Field Equipment Manual TMG E1261

Issued August 2012 UNCONTROLLED WHEN PRINTED Version 2.1

3.1 Maintenance Tasks.................................................................................................................43

3.1.1 Corrective Maintenance...........................................................................................43

3.1.2 Preventative Maintenance.......................................................................................43

3.1.3 EPROM Replacement or Configuration Data Change............................................44

3.1.4 Interrogating the Monitor..........................................................................................45

3.1.4.1 PIN Numbers............................................................................................45

3.1.4.2 Using the MS-DOS Program LX_MAINT.................................................46

3.1.4.3 Using the Windows Program CERBERUS...............................................49

3.2 Tools and Maintenance...........................................................................................................50

3.3 Maintenance Instructions........................................................................................................50

3.4 Incident Investigation ..............................................................................................................51

4 Fault Diagnosis .....................................................................................................................51

4.1 General....................................................................................................................................52

4.2 Faults reported by Operations ................................................................................................52

4.3 Faults Detected during Maintenance......................................................................................53

4.3.1 Monitor does not report a status change.................................................................53

4.3.2 Changes are not appearing in the log .....................................................................53

4.3.3 Lamp Learn does not complete within 40 seconds.................................................53

4.3.4 Lamp Learn rejects the results................................................................................53

4.3.5 Lamp problem detected while Crossing operating..................................................54

4.3.6 Lamp problem detected while Crossing not operating............................................55

4.3.7 Battery test does not work.......................................................................................55

4.3.8 Monitor indicates a Fault..........................................................................................56

4.3.9 Monitor indicates a SYS Fault.................................................................................56

4.3.10 Monitor indicates a Warning....................................................................................56

4.3.11 Unable to communicate with the monitor locally .....................................................56

4.3.12 Unable to communicate with the monitor remotely .................................................57

4.3.13 LEDs on the SCADA card not behaving normally...................................................57

4.3.14 Monitor restarting unexpectedly ..............................................................................57

4.3.15 Clock stopped or showing invalid time ....................................................................57

5 Installation .............................................................................................................................57

5.1 Circuit Design considerations .................................................................................................57

5.1.1 General....................................................................................................................57

5.1.2 Battery Test Outputs................................................................................................58

5.1.3 Battery Test Relay...................................................................................................58

5.1.4 Non-Vital Timer........................................................................................................58

5.1.5 Test Load Resistor...................................................................................................59

5.2 Equipment Installation.............................................................................................................59

5.3 Hardware Configuration..........................................................................................................60

5.4 Commissioning Procedure......................................................................................................60

6 Data Configuration................................................................................................................63

6.1 Configuration Data Description...............................................................................................63

6.1.1 Scope of data...........................................................................................................63

6.1.2 Permanent Configuration data syntax.....................................................................63

6.1.2.1 Comments................................................................................................63

1 2 3 4 5 6 7 8 9 10 ... 88 89

Kommentare zu diesen Handbüchern

Keine Kommentare

Dataplex DPX-213 Spezifikationen Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Dataplex DPX-213